Defective Metal Beam Crash barrier

Written by Team Highway Correspondence

Updated on:

Defective Metal Beam Crash barrier

Here’s information about a defective metal beam crash barrier on a project highway.

During the highway operation phase, the installed metal beam crash barrier experienced a defective condition due to the following factors:

  1. loss of its shape, position
  2. Affected by age and vehicle hits.

According to the Concession Agreement (CA), the concessionaire must maintain all project aspects, features, and facilities in conformity with good industry practices. This includes repairing and correcting defects and deficiencies. repair and restoration within the time limit set forth therein.

The independent engineer (IE) has an obligation to inspect the project highway and identify defects. The IE is also required to compile a report detailing the defects they have found. And issue a notification to the contractor for repair, based on the clause above.

The forthcoming information showcases some findings and comments from the IE about a defective metal beam crash barrier.

Letter on defective metal beam crash barrier on the Highway Project-Reg

A formal letter has been sent to the consultant about this issue. This story is about a faulty metal beam crash barrier. It highlights various safety issues like damaged, lost, or defective crash barriers. It’s been sent to the concessionaire, asking them to rectify the problem.

To

The Concessionaire­,

Subject: Defective Metal Beam Crash Barrier.

De­ar Sir,

We conducted a site inspection on the project highway. The site inspection revealed a variety of safety concerns related to defective and damaged MBCB.

The following are the various defects of the W-beam crash barrier on the project highway.

Defective metal beam Crash barrier: case 1 Reduced heightdefective metal beam crash barrier

The image illustrates the reduced height of the MBCB at ROB’s after a periodic overlay.

The issues are at specific sites, including high embankments and bridge approaches. The height of the barrier has diminished after periodic overlays. The height reduction varies from 100 to 300 mm. Embankment settlements occur in the following locations:

(a) At ROB km. 14+500

(b) At Major Bridge, approach slabs at km. 30+200.

On the contrary, you are instructed that it’s important to maintain the standard height of the barrier immediately, especially in high embankment areas that could pose a serious safety hazard.

The MBCB from the BC top should have a typical height of 925 mm. For reference, please refer to IRC: 119 Guidelines for Traffic Safety Barriers, Fig. 11. The typical details of the ‘W’ structural elements will follow.

Defective metal beam Crash barrier: case 2 Missing, lost, or damaged

Defective Metal Beam Crash barrier

The image displays the lost or missing length of MBCB on the structure.

We have also noticed lost or missing certain lengths of metal beam crash barriers at km. 5+000 and km. 12+500, due to an accident or other reasons. This can lead to unsafe situations, particularly at night. It’s crucial to repair or replace the missing lengths immediately.

Hence, we must reinstate or replace the missing length of the MBCB on a priority basis. The time limit for repair and rectification is as per the CA stipulations.

Defective metal beam crash barrier: case 3: Improper end connections of the MBCB

Improper connections to the barrier are observed at locations like km. 15+000, km. 18+200, and km. 31+650.

In all these locations, a gap exists between the structure’s RCC barrier and the MBCB.

Due to such conditions, two-wheelers suffer from protruding ends of the MBCB. These loose ends can cause accidents, especially for two-wheelers.

All these location gaps must be filled and proper end connections made to the structure barrier as per IRC 119 Guidelines for Traffic Safety Barriers. For reference, see Page No. 16, Fig. 16 W. The beam-to-concrete connection details will follow.

Contractual Provisions for Rectification of Defective Project Facilities/Metal Beam Crash Barrier

  1. According to CA clause 1.1 of Schedule K, the concessionaire shall, at all times, operate and maintain the project highway in accordance with the agreement’s provisions.
  2. Under clause 1.2, the concessionaire is required to repair or rectify any defect or deficiency outlined in Schedule K within the specified time limit, as well as any failure.
  3. Also, under clause 3, the concessionaire is responsible for fixing any problems that aren’t listed in Annex 1 of this Schedule K. The concessionaire must carry out this task in a manner that aligns with industry best practices.

According to the above contractual conditions of CA, as part of their maintenance duties, the concessionaire must promptly repair any defects, correct any deficiencies, and address unlisted problems in accordance with industry best practices.

Conclusion

On this basis, you are notified to repair or rectify the defective barriers at the mentioned sites to tackle the safety issues caused by them in the project corridor. Submit your action report at the earliest opportunity.

Sincerely,

[Insert the name of the authorized person].

Note to Visitor

Please note that the contract conditions shared here are examples. These derive from the CA of the DBFOT project under the PPP mode for 2018–2020.
Necessary changes to the existing contract terms need to be made according to the specific project to draft a similar notice.

Read the notice on highway safety defect intimation to the concessionaire or contractor on Project Highway.

Also read various other sample draft formats of letters during operation and maintenance phases, such as bridge structure, toll, and safety. The highway project at this site also encompasses other related elements.

Defective Metal Beam Crash Barrier: FAQs

What is the standard height of the MBCB?

The standard height of MBCB from BC top should have a typical height of 925 mm.

What are some common defects in metal beam crash barriers?

Reduced height: not to the standard height of the BC top surface.
Missing, lost, or damaged: which is due to accidents
Improper end connections of the MBCB to the RCC barrier

Leave a Comment